Multiple Node Processor Install

[Chris Albright]

I want to install a second Node and dongle so I can process multiple cases in parallel. One Node is already installed on the Connect server (local) and I want to install a second Node and dongle on a second server.  What are the install and configuration steps to do so for the Connect server and the second Node server?

I read the manual section for Remote Node processing, but not sure if/how that applies here.

Thanks in advance.

[jon.pearse]

Hi Chris,

You just install Node on the new system, and plug your new dongle into that system (you will receive the activation instructions soon). Once done, the information and steps for adding Nodes to Connect is shown in Section 7.3.2 of the Connect admin manual.

Note that all processing/Node systems should be separate to your Connect server. Processing cases with Node/Pro, and sharing cases on the same system is not supported.

[Chris Albright]

Ummm... 7.3.2 says Usernames... Is it the info in Chapter 3/4? We're on 2.3.1.

[jon.pearse]

Hi Chris,

It is in the 2.4 Connect admin manual. We will send you a link in the support portal. 

 

 

[Chris Albright]

Thank your the quick response.  I was able to get it up and running.  I'll do some testing to make sure all it is all good to go.

Much obliged,

Chris